Six technical requirements for outdoor stage sounds. Sound system and feedback are especially important.

Many people think that indoor and outdoor stage audio equipment and systems are the same. In fact, due to different venues, the stage sounds that are often used will be different. Therefore, you can't use the same scheme to configure different stage sounds. Today, let's talk about some requirements of outdoor stage audio equipment. Of course, specific problems should be analyzed. These requirements are only applicable to the sound configuration of most indoor stage.

Six technical requirements for outdoor stage audio equipment

 First, the sound system must have a strong power reserve: outdoor open sound field, need to have strong power, because the outdoor sound field should increase the sound pressure level of 3db, the power needs to increase by 10 times, according to the formula 10logp2 / p1 = xdb, can Calculate the specific value of the sound field.

Second, the speaker should be hoisted: the position of the outdoor literary performance speaker can not be too low, the sound of the low-level speaker is easy to be absorbed by the audience, resulting in grazing and sound absorption, especially the high-end audio loss, so it should be installed by lifting the speaker. The midrange or treble horn and the outdoor dedicated speaker (the speaker has a high-powered treble horn), so that the sound waves of the speaker radiate far away in the air, so that the audience can get enough loudness.

Third, choose high sensitivity mic, which can enhance the mic's sound gain, so that the audience can get enough loudness. Outdoor performances often have a long distance between the MIC and the mixer, so it is better to use a wireless MIC for proper pickup.

Fourth, protect the power line: the energy of the speaker system is from the grid circuit, if the power circuit fails, the sound system will have problems. Therefore, the power circuit should be supported by a local professional electrician. The entire line mixer to indoor or temporary power generation vehicles should be protected by special security personnel.

Fifth, protect the speaker line: the distance between the outdoor performance power amplifier and the speaker is generally far. In order to prevent the fault and damage of the amplifier caused by the open and short circuit of the speaker line, there must be a special person to protect the speaker line, and the output impedance of the power amplifier is very small. Only a few ohms, but the sound power is very large, so the current is also relatively large, the line distance is not too long, and the cut-off area should not be too small, so as to avoid unnecessary sound power loss, if possible, the power amplifier can be Place it closer to the speaker to reduce unnecessary wear and tear.

6. The sound engineer should keep in touch with the assistant of the auditorium through the walkie-talkie, so that the sound engineer can grasp the sound effect of the auditorium more accurately and in time, so as to make timely adjustments.

It can be seen that the outdoor stage audio equipment is mostly only suitable for outdoor occasions due to the wide space of the venue, etc., especially for some audio systems. This type of sound system is used indoors, and the sound effect may be very poor. Nowadays, there are many outdoor performances, and the construction of stage audio equipment must have professional technology and equipment to let the audience get the best feeling.

© Copyright Dongguan Rongyin Electronic Technology Co., Ltd All rights reserved.     粤ICP备18037305号-1     Technical support:SZTD